Technical Manual

Technical Manual RF Mono
Cross Point Device Explorer v1.4 Page 44 of 47
Uploading new firmware 7.8.5.3
In case new firmware is available, you can automatically upgrade all devices of the same
type by pressing the Update all button .
Removing disconnected devices 7.8.5.4
All devices that have the disconnected status can be removed permanently by pressing
the Remove disconnected devices button .
Turning all LEDs on/off
7.8.5.5
The LEDs on all connected devices can be switched on at once by pressing the Turn all
LEDs on button . This is useful to check whether all devices are connected, especially
in large installation. Press this button again to switch all LEDs off again.
Resetting all connected devices 7.8.5.6
Press the Reset all button to reset all connected devices at once.
Changing the name of a device 7.8.5.7
Move your mouse cursor over the device name of the device in the Device column and a
text field will appear. Click on the text field of the device you want to change and enter the
new name. Repeat this for all names you want to change. Click the Apply button to save
the new settings.