Technical Manual

Technical Manual RF Mono
Cross Point Device Explorer v1.4 Page 41 of 47
7.8.2 RF settings
The RF settings screen enables you to configure various system settings for all RF Mono
antennas that are connected. In case Checkout RF Deactivators are also connected, then
synchronization for these devices settings can also be configured here.
Figure 36: System settings
Only one master antenna is allowed on the Field Bus. Select one of the available
antennas from the master drop-down box to appoint that antenna as master for the
complete system. It is always recommended to select the antenna in the middle of the
total bus as master.
The total transmission bandwidth is configured by selecting a Begin of sweep and End of
sweep frequency. The default transmission bandwidth is 7400 kHz – 8800 kHz.
System setting
Explanation
Master
Master antenna selection
Begin of sweep
Bandwidth start frequency
7400 kHz, 7500 kHz, 7600 kHz, 7700 kHz, 7800 kHz, 7900 kHz or 8000 kHz
End of sweep
Bandwidth end frequency
8200 kHz, 8300 kHz, 8400 kHz, 8500 kHz, 8600 kHz, 8700 kHz or 8800 kHz
Sweep frequency
Set the desired sweep frequency
185 Hz (= default), 180 Hz, 175 Hz, 170 Hz
Table 5: System settings