Technical Manual

Technical Manual RF Mono
Cross Point Device Explorer v1.4 Page 40 of 47
7.8 System
Clicking the System hyperlink in the Main menu or clicking the System information
section in the dashboard will open the System information screen. Through the System
screen, various system-wide settings can be configured and applied to all devices on the
Field Bus.
Figure 35: System information
The top-part of this screen shows information about the connected transceiver(s) and
whether the firmware of all connected devices is up-to-date.
The bottom part shows the following tabs:
7.8.1 Notifications
In case of an alarm situation, notifications will be used to draw attention and to present
information about the type of alarm.
Notifications can be set for all entrances at once by configuring the notifications in this
System screen. In case different notifications per entrance are required, select the
entrance and specify the required notification settings at entrance level. See section 7.7.4
for more details.
Notification settings, which are configured in this System screen, will be
applied system-wide, which means to all devices connected to this
Access Point. Any notification settings that have been configured for a
specific entrance will be overwritten with the values that are specified in
this System screen!
In case devices with normal LEDs and RGB LEDs are detected, a message indicating
that it’s not possible to configure notifications at system level will be shown.
Refer to section 7.7.4.1 for more details on the available notification settings.