Technical Manual

Technical Manual RF Mono
Cross Point Device Explorer v1.4 Page 39 of 47
Notifications – I/O settings 7.7.5.2
Next to the audio and visual alarm notifications, as described in section 7.7.4.1, also a
relay and a maximum of 2 I/O’s can be configured to activate any external device
(camera, external buzzer, etc.) during an alarm situation.
These notification settings have to be configured on each individual antenna, since the
relay and I/O’s are antenna specific. Any externally connected device needs to be
physically connected to the antenna.
Figure 34: Notifications – I/O settings
Relay and I/O notification settings apply only to an individual antenna!
The following notification types can be selected by clicking on the cell in the top left
corner of the notifications table:
 Alarms
 Visitor counters (Optima models only)
 Other
Refer to section 7.7.4.1 to view all available notification types.