Technical Manual

Technical Manual RF Mono
Cross Point Device Explorer v1.4 Page 30 of 47
Tag 7.7.4.1.1
The following tag alarm notification is available for the RFM system:
Notification
Explanation
Tag detected
This notification can be used as a ‘pre-alarm’ feature when the
option “Use visitor counter to distinguish in- and outgoing
alarms” has been enabled.
Table 2: Alarm notification
For RFM Optima models the Incoming, Outgoing and Undefined tag alarm notifications are also not
available.
Visitors 7.7.4.1.2
Available for Optima models only.
Notification
Explanation
Incoming visitor
When a visitor enters the store, a ‘doorbell’ notification can be
triggered to notify employees in the store that a visitor has just
entered the store.
Outgoing visitor
When a visitor leaves the store, a ‘doorbell’ notification can be
triggered to notify employees in the store that a visitor just left
the store.
Visitor counter blocked
When the infra-red beam of the visitor counter is blocked for a
specific minimum amount of time (default 30 seconds), a
counter blocked notification can be triggered to notify visitors
and employees in the store that there is an aisle blockage.
NOTE: The wait time before visitor counter blocked can be
adjusted to another value if required. Just specify a value
between 1 and 3600 seconds.
Table 3: Visitors notifications