Technical Manual

Technical Manual RF Mono
Cross Point Device Explorer v1.4 Page 20 of 47
7 Cross Point Device Explorer
This chapter covers the RF Mono antenna settings in combination with the Cross Point
Device Explorer software.
Please refer to chapter 2.2 for details on the Field Bus structure.
For the Cross Point Device Explorer installation procedure and other general settings we
refer to the Cross Point Device Explorer User Manual (download available at
www.crosspoint.nl).
Make sure to keep your laptop at least 3m away from the antennas. The
back light of the laptop screen can create a lot of noise and might
reduce the performance of the system!
7.1 Starting Device Explorer
After having installed the Cross Point Device Explorer, go to
Start > All programs > Cross Point > Device Explorer
(or your, during installation specified, destination folder) to start the Device Explorer.
7.2 Logon to Device Explorer
After starting the Device Explorer, you will be prompted to enter your username and
password that allow you to use the Device Explorer.
Figure 10: Logon to Device Explorer
These credentials have been supplied to you by Cross Point or a partner of Cross Point.
Tick the “Save credentials” checkbox if you want to use the specified logon credentials
each time you start the Device Explorer.
Enter your credentials and click the Logon button to continue.