Technical Manual

Technical Manual RF Mono
Configuration v1.4 Page 17 of 47
6 Configuration
This chapter describes the recommended adjustment procedure for the RF Mono
transceiver.
6.1 General connections
 Refer to chapter 3 for noise sources and installation guidelines.
 Position the antenna(s) at the required location.
 Connect the power supply to the power input of the RF Mono board. See section
5.5 for power supply information and restrictions.
 Connect UTP cables between all RF Mono boards in case of a multiple antenna
setup
 Switch on the power supply → the power LED on the RF Mono PCB should light
up.
 Wait for about 15 seconds for the system to start up completely.