User's Manual

D SCAN AUTHENTICATOR CF 2-3
Installation
Top of the document reader
The following section contains important details of the top of the device with a
brief description of each. The ambient light cover has been opened to better show
the details.
Table 2.1 Front features
# Description
1
Ambient light cover. The height-adjustable cover reduces outside light during
operation and protects the document contact area when the device is not in use.
2
Document contact area. The glass bearing surface where you put the
documents to verify. The surface is divided into the optical scan area and the
document support area. The entire document contact area is covered by the
RFID antenna.
3
Smart Card slot. The integrated contact smart card reader allows maximum
application comfort and uses the ISO 7816 protocol Type T=0 (asynchronous
half duplex character transmission protocol) and T=1 (asynchronous half duplex
block transmission protocol) to read cards.
4
Status LEDs and Buzzer. Three LEDs can provide visible indications and a
volume-adjustable buzzer provides acoustical indication about the current mode
of the document reader.
Using the D SCAN Extensions application the LEDs light as follows:
•The backlit red light is the Status light and lights during the initialization
process or when the device is not ready for operation.
•The backlit yellow is the Processing light and lights when processing a
document. During this time, no other documents can be verified. After
processing it turns off, indicating that a new authentication can be started.
•The backlit green is the Operation light and lights after the device is
successfully initialized and when an authentication is completed.
Other programs can use the lights and the buzzer in different methods.
5
Instruction label. The label informs the user in principle how to position and
place a document correctly.