User's Manual

5-2 D SCAN
®
AUTHENTICATOR CF™ User Manual V2.0
Maintenance
Cleaning the case
Warning Before you clean the case, disconnect the D SCAN AUTHENTICATOR CF from the
grounded outlet.
To remove smudges, laminate glue, finger prints or other dirt, and grime:
1 Take a soft, lint free cloth and put a small amount of glass cleaner on it.
2 Carefully wipe the case in a direction AWAY from the document contact area.
Caution Do not use acetone, oil-based, abrasive or other unauthorized cleaners. This may damage
the device and render it inoperable. Using unapproved cleaning solutions will void the
warranty.
Specifications
Table 5.2 Product specifications
Item Specification
Resolution Native 475 ppi sensor for best recognition of high
density features
Dynamic range White light and UV24 bit RGB color, IR light: 8 bit
gray scale
Illumination Standard: white light, IR light and coaxial light (not
available in all markets)
Optional: UV
Document support field size 5.9” x 7.4” (151 x 189 mm), document thickness is
not limited
Optical scan format Active size 5.3” x 3.9” (135 x 100 mm)
Optical scanning time approx. 2 seconds for all images combined
Supported documents Compliant with ICAO 9303 documents of ID1,
ID2, and ID3 format, other ID-1, ID-2 and ID-3
documents on request
Document thickness Not limited
RFID chip access According to ISO 14443 Type-A and Type-B plus
applicable ICAO recommendations in ICAO Doc
9303 including supplement, LDS 1.7,PKI 1.1
RFID speed All standardized rates, up to 848 Kbps, read-out
times depend on RFID tag, operating system, and
amount of data stored in the chip
Smart card reader Contact SmartCard reader with landing contacts
and able to read cards according to ISO 7816
protocol Type T=0 (asynchronous half duplex
character transmission protocol) and T=1
(asynchronous half duplex block transmission
protocol).
Environmental conditions Indoor use, climate classification according to DIN
EN 60 721-3-3
Temperature range 50°F to 113°F (+10°C to +45°C)