User's Manual

System diagnosis 3-5
Starting the first time
Figure 3.5 User controls page
Note A physical defect LED or beeper cannot be detected automatically. It is necessary to
observe the test patterns to identify any malfunction or defect manually. An observed
malfunction should be added manually to the log file as a Comment at the Tests Completed
Page.
3 Click Next to finish the test session. The RFID reader page appears.
Testing the RFID reader
The document reader contains a RFID reader, which is able to communicate with
RFID chips. By examining the document reader properties you are able to test it.
•The RFID reader page shows a list of all available RFID tests containing
Tests and Status information.
• The tests can be performed either as single tests separately or testing all in
sequence by using the buttons Test or Test All.
1 Enter the Tag Name (1) of the document, which is placed for testing.
2 Testing all modes is the default setting where all communication tasks will be
performed. Start the test routine by clicking Test All.
•The column Status shows which test will be performed and whether the test
was successful. Not successfully tests displaying an error number.
• Experienced users are able to perform single tests. To do so, highlight the
desired test item using the mouse cursor and click the button Test to start the
test.