User's Manual

2-8 D SCAN
®
AUTHENTICATOR CF™ User Manual V2.0
Installation
4 Insert the cable connectors into their related connectors in the connection box.
Figure 2.7 D SCAN AUTHENTICATOR CF connection box
5 Connect the power supply to the AC electrical outlet.
• All LEDs should quickly flash on and off. The orange LED comes on again
flashing indicating the standby mode.
Note When the power is applied to the D SCAN AUTHENTICATOR CF, it is permanently powered
on. Unplug the device from the AC electrical outlet, if you want to completely power-down
the device.
6 Connect the other end of the USB cable to the USB 2.0 port of your computer.
7 You have completed the procedure.
Note Before you connect the D SCAN AUTHENTICATOR CF to the USB port of your PC you
must install the D SCAN Essentials software, which copies all the required hardware driver
files into the same directory, where they can be easily accessed during the D SCAN
AUTHENTICATOR CF installation.
You can use any USB port when plugging in the D SCAN AUTHENTICATOR
CF. However, the first time you plug the device into a particular port, Windows
will install the driver for that device again. The Found New Hardware message is
displayed in the notification area, at the far right of the taskbar or the Found New
Hardware Wizard starts automatically.
21