User's Manual

D SCAN AUTHENTICATOR CF 2-3
Installation
Top of the document reader
The following section contains important details of the top of the device with a
brief description of each. The ambient light cover has been opened to better show
the details.
Table 2.1 D SCAN AUTHENTICATOR CF major components
# Description
1
Ambient light cover. The height adjustable cover is used as a mask to reduce
outside light during operation and protects the document contact area when the
device is not in use.
2
Document contact area. The glass bearing surface where documents are
placed to be verified. It is divided into the optical scan area and the document
support area. The entire document contact area is covered by the RFID antenna.
3
Smart Card slot. The integrated contact smart card reader allows maximum
application comfort and is able to read cards according to ISO 7816 protocol
Type T=0 (asynchronous half duplex character transmission protocol) and
T=1 (asynchronous half duplex block transmission protocol).
4
Status LEDs and Buzzer. Three LEDs can provide visible indications and a
volume adjustable buzzer provides acoustical indication to the user about the
current mode of the document reader.
Using the D SCAN Master application the LEDs light as follows:
The backlit red light is the Status light and lights during the initialization process
or when the device is not ready for operation.
The backlit yellow is the Processing light and lights when processing a
document. During this time, no other documents can be verified. After
processing it turns off, indicating that a new authentication can be started.
The backlit green is the Operation light and lights after the device is
successfully initialized and when an authentication is completed.
Other programs can use the lights and the buzzer in different methods.
5
Instruction label. The label informs the user in principle how to position and
place a document correctly.