Palm Harbor Outdoor Wicker Chaise Lounge CO7122-BR
PART LIST Front Panel 1pc A 1pc B Left Side Panel Bar Cushion 1pc H 1pc F U Bar 1pc G Backrest Panel 1pc E 1pc C Seat Panel 1pc D Right Side Panel Back Panel 1pc I HARDWARE LIST Short Bolt(M6*20mm) J 6pcs Plastic Washer N 4pcs Nut(M6mm) Long Bolt(M6*45mm) K 15pcs L Allen Key(M6mm) O 2pcs Wrench(M6mm) 1pc P 2 1pc Flat Washer(M6mm) M 23pcs
Step 1. Lay the Right Side Panel (C) down on a flat surface, and attach the Front Panel (A) to the Right Side Panel(C) using a Long Bolt (K) and Flat Washer (M). NOTE: Please do not tighten bolts before fully completing all assembly steps. Step 2. Attach the Seat Panel ( E) to the Right Side PaneL ( C ) and the Front Panel (A) using a Long Bolt (K) and Flat washer(M).
Step 3. Attach the Back Panel ( B) to the Right Side Panel (C) using a Long Bolt (K) and Flat Washer(M). Step 4. Attach The Left Side Panel ( D ) to Front Panel ( A ), Back Panel (B) and Seat Panel ( E ) using a Long Bolt (K) and Flat Washer(M).
Step 5. Attach the Bar ( G ) to the Right Side Panel (C) and Left Side Panel (D) using a Short Bolt ( J ) and Flat Washer(M). Step 6. Lay the Backrest Panel ( F) down on a flat surface, attach the U Bar (H) to the Backrest Panel ( F ) using a Short Bolt (J ), Flat Washer(M), Plastic Washer (N) and Nut (L).
Step 7. Attach the assembled Backrest Panel ( F) to the Right Side Panel (C) and Left Side Panel (D) using a Long Bolt ( K ), Flat Washer(M) and Plastic Washer(N). Step 8. Place the Cushion (I) on top of the lounge chair.
Warning: Before using please make sure the position is stuck fully with the bar.
