Outdoor Wicker Trash Can CO7306
PART LIST A C B Back Panel 1 PC F Front Panel 1 PC E D Side Panel 2 PCS Bottom Panel 1 PC Top Panel 1 PC NOTE: We recommend using a 13-16 gallon bag with a thickness of .90 to 1.2 mil for standard refuse (thicker bags may be required for more durable refuse such as yard waste).Using a bag that is too large or overloading the trash can may result in difficulties removing the bag.
Lay front panel (part B) down on a soft flat surface,such as carpet as shown below.Attach side panels (part C) to front panel (part B) using long bolts (part #2),washers (part #4) and allen key (part #5). NOTE: Please do not fully tighten bolts until unit is fully assembled. #5 #2 #4 #2 x4 #4 x4 #5 x1 Attach bottom panel (part D) to side panels (part C) and front panel (part B) using long bolts (part #2), washers (part #4) and allen key (part #5).
Attach back panel (part A) to side panels (part C) and bottom panel (D) using long bolts (part #2), washers (part #4) and allen key (part #5). NOTE: Please do not fully tighten bolts until unit is fully assembled. #4 #2 #5 #2 x5 #4 x5 #5 x1 Carefully turn trash can upright.Attach top panel (part E) to back panel (part A) using inner thread bolts (part #3), short bolts (part #1) and both allen keys (part #5) as shown. NOTE: Please fully tighten all bolts at this time.
Place garbage bag (not provided) inside the trash can as shown, and secure in place with garbage bag holder (part F). NOTE:Please see page 2 for info on garbage bag size. Top panel (part E) can be opened and closed.
