Instructions / Assembly

Do not
Attach
5
Flathead screw
driver(not included)
Figure 2
5
4
4
2
3
1
2
3
Step 2: Attach two adjacent Legs (B)
by inserting the Cylinder Bolts (Part #1)
through the holes in Legs (A) by fitting
the leg on top of the attached cylinder
bolt.Secure the Legs (B) using Flat
Washers (Part #3),Spring Washers
(Part #2),and Nuts (Part #4).
Note - -Tighten the Nuts (Part #4) only
half way at this time using
wrench (Part #6).
Step 3: Attach Stretcher (C) to the two
attached Legs (A) with Flat Washers
(Part #3),Spring Washers (Part #2),
and Nuts (Part #4).
Note - -Tighten the Nuts (Part #4) only
half way at this time.
Step 4: Cover all Nuts (Part #4) with
Nut Caps (Part #5).Turn the table
over to the upright position.Adjust
the levelers on the bottom of the legs
to level the table.
Attach the other two legs (B) to the
Top (B) & Stretcher (C) using the
same method as the first two legs.
Tighten all Nuts (Part #4) completely.
.
Insert all Cylinder Bolts(Part #1) into
Step 1:
Flat Washer
Nut
3
4
Nut Cap
5
Spring Washer
2
Bolt
x 4
x 8
x 8
x 8
x 8
1