Manual

Features
Cycle Signal Control (some models)
When the Cycle Signal Control is ON, asignal will sound at the end of each cycle and
during the PressSaver setting (some models). The volume is adjustable on some
models.
Drum Light (some models)
A drum light will come on whenever the door isopened to illuminate the dryer drum
during loading and unloading. Closing the door turns off the light.
Use the drying rack to dry items which should
not be tumbled.
Drying Rack (some models)
Usethe drying rack to dry items which should not be tumble dried.
1. Open the dryer door and remove the lint screen.
2. Insert drying rack into the dryer drum. Placethe front bar under the lip of the lint
screen opening.
3. Place items to be dried on top of rack. Weight should not exceed 10 Ibs. Leave
space between items, but do not let items hang over the sides or through the
grids. Do not tumble other items when using the drying rack.
4. Selecta timed dry setting best suited for items being dried. Useonly the Air Fluff
(no heat) temperature setting for items containing plastic, foam rubber, rubber-
like materials, feathers or down.
5. When items are dry, remove the rack and replace the lint screen. If lint screen
isnot in place, tumbling items could enter the exhaust system and cause damage
to the dryer.
Common Drying
Problems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage.
For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.
PROBLEM
Greasy, oily
stains
Lint
Pilling
(Fibers break off,
ball up and cling
to fabric.)
Shrinking
Wrinkling
POSSIBLECAUSES SOLUTIONS PREVE_VE MEASURES
oFabric softener sheet, oRub fabric softener stains with bar soap. oAdd a few bath towels to small loads for proper
Rinse and rewash, tumbling.
oSome "silk-like" fabrics should be air dried.
oUse proper drying temperature.
oPlace fabric softener sheet on top of load before
starting the dryer.
oOverloading, oReduce load size and rewash using liquid
oOverdrying causes static fabric softener in the final rinse.
electricity, oOr, add afabric softener sheet and tumble
oLint screen not clean when at low heat for 5-10 minutes.
cycle began, oUse lint brush or roller to remove lint.
oLint isattached to "pills."
oPilling is normal with synthetic°Use a lint brush or shaver to remove pills.
and permanent press fabrics.
This is due to abrasion from
normal wear.
oDo not overload dryer.
oUse fabric softener in washer or dryer to reduce
static electricity.
oRemove items when they are slightly damp to
avoid overdrying.
oCheck that lint screen is clean and in place.
• Use fabric softener to lubricate fibers.
oWhen ironing, use spray starch or fabric finish on
collars and cuffs.
oTurn items inside out to reduce abrasion.
oOverdrying.
olrreversible condition. oFollow fabric care label directions.
olf shrinking is a concern, check load often.
oRemove items while slightly damp.
oBIock knits into shape.
oLay flat to complete drying.
oOverloading, oReduce load size and tumble at low heat oDo not overload dryer.
oLeaving items in dryer after cycle for 5-10 minutes, oRemove items as soon as cycle ends.
ends. oRemove items immediately. Hang or fold.
10