Manual

3. Slide the shelf grommet into the grommet
already in the freezer wall until it is flush.
To install the handle clips to the basket:
1. Place the basket on a firm, fiat surface.
2. With the narrow side of the handle clip on
the inside of the basket, snap the handle
clip to the recessed area in the basket.
Door Removal
if door must be removed, unplug the unit,
1. Gently lay appliance on its back, on a rug
or blanket.
2. Remove two base screws and base panel.
3. Remove bottom hinge screws.
4. Remove plastic top hinge cover.
5. Remove screws from top hinge.
6. Remove top hinge from cabinet.
7. Remove door and bottom hinge
from cabinet.
8. To replace door, reverse the above order
and securely tighten all screws to prevent
hinge slippage.
3.
Once the inside surface snaps in place,
continue the process by rolling the handle
clip slightly outward and pressing down
firmly to snap onto the outside surface. If
installed incorrectly, the handle clip will not
lay fiat.
Cool Down Period
o For safe food storage, allow 4 hours for
appliance to cool down completely. The
freezer will run continuously for the first
several hours. Foods that are already frozen
may be placed in freezer after the first few
hours of operation. Unfrozen foods should
NOT be loaded into freezer until freezer has
operated for 4 hours.
When loading freezer, freeze only 3 pounds
of fresh food per cubic foot of freezer space
at one time. Distribute packages to be frozen
evenly throughout the freezer. It is not
necessary to turn control knob to a colder
setting while freezing food.
Electromechanical Temperature
CONtrOl (chest and some upright models)
The electromechanical temperature control is
located inside the freezer on upright models,
and on the left exterior wall on chest models.
The temperature is factory preset to provide
satisfactory food storage temperatures. However,
the temperature control is adjustable to provide a