Manual

WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend that you use a gas detector approved by UL or CSA.
For more information, contact your gas supplier.
If a gas leak is detected, follow the "What to do if you smell gas" instructions.
CHECKING YOUR VENT
Your dryer must be properly installed and vented to achieve
maximum drying efficiency and shorten drying times. Use the
minimum recommended installation clearances found in the
Installation Instructions. See the Installation Instructions for more
information.
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can result in death
or fire.
If the dryer is not properly installed and vented, it will not be
covered under the warranty. The dryer exhaust must not be
connected into any gas vent, chimney, wall, ceiling, attic,
crawlspace, or concealed space of a building.
Proper venting of your dryer is important for satisfactory
drying results. See the Installation Instructions for more detail.
N!)E: Service calls caused by improper venting will be paid for
by the customer, whether it was a paid installation or self-
installed.
1. Use a 4" (102 mm) heavy metal exhaust vent and clamps.
Flexible metal vents are acceptable only if accessible for
cleaning. The total length of flexible metal vent should not
exceed 7 3/4 ft (2.4 m). Do not kink or crush flexible metal vent.
It must be completely extended to allow adequate exhaust
air to flow. Check vent after installation. Refer to the Installation
Instructions for proper length requirements of vent.
2. Use a 4" (102 mm) exhaust hood.
lg rnrn
1_ mm
3. Use the straightest path possible when routing the vent.
Good Better
4. Use clamps to seal all joints. Exhaust vent must not be
connected or secured with screws or other fastening devices
that extend into the interior of the duct and can catch lint. Do
not use duct tape.
5. Clean exhaust vent periodically, depending on use, but at
least every 2 years, or when installing your dryer in a new
location. When cleaning is complete, be sure to follow the
Installation Instructions supplied with your dryer for final
product check.