Installation guide

INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.
Tools needed:
c=
ar—
Flat-blade screwdriver #2 Phillips screwdriver
1) es —r-79
a ee >
Wire stripper Tin snips
(direct wire installations) (new vent installations)
=CG
1/4" nut driver
(recommended)
Vent clamps
<=
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife
<a)
—_
Tape measure
Pliers
QQ
~~
Level Caulking gun and
compound (for installing
new exhaust vent)
Parts supplied (ail models):
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed:
Check local codes. Check existing electrical supply and venting,
and read “Electrical Requirements” and “Venting Requirements”
before purchasing parts.
Mobile home installations require metal exhaust system hardware,
available for purchase from the dealer from whom you purchased
your dryer. For further information, please reference the
“Assistance or Service” section of the “Use and Care Guide”.
if using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
@ A UL listed 30-amp power supply cord, rated 120/240 volt
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to the
dryer must end in ring terminals or spade terminals with
upturned ends.
@ A UL listed strain relief.