Product Manual

1514
(24) Operation identification (Not running)
(25) Battery (loss of) capacity
(26) Manual start information
(27) Battery (More than 8V / less than 10V)
(29) Fault identification
(30) Fault code symbol
(31) Maintenance identification
(28) Maintenance
NOTE: The interface content of 23 is used for the MAC
address of connecng Bluetooth device.
The display interface can be switched by operaon of key
7, and the contents are displayed in turn.
When the above contents are displayed in each display
interface, the contents of 8, 9 (displayed with Bluetooth,
not displayed without Bluetooth) and 10 are also displayed
at the same me.
4. When engine runs with failure: the screen interface
displays the contents of 29-30, and the content of 30
represents the fault informaon as follows:
U> a: AC over voltage, indicang the character of AC
(alternave indicaon of AC and digit)
U< a: AC under-voltage, indicang the character of AC
(alternave indicaon of AC and digit)
I> Output over current of generator.
Output short circuit of generator.
Over heat of frequency converter.
NOTE: When the above contents are displayed in each
display interface, the contents of 9 (displayed with
Bluetooth) and 10 are also displayed at the same me.
5. When the engine switch is in the “ON” posion, and the
engine is either running or not, the screen interface will
display content 28 advising a service interval is required.
If the service has already been carried out , operate key 7
to clear this informaon.
NOTE: Operate key 7 to clear the maintenance
informaon, the screen automacally switches to the next
interface.
If key 7 is not operated to clear the maintenance
informaon, the content of 28 will be displayed once every
1 minute in each screen interface for 10 seconds and the
content of 28 will not be displayed again unl 2 hours
later. At the same me, the maintenance mark will not be
displayed on the right side of the Bluetooth mark on the
screen interface, unl the generator set is maintained and
key 7 is operated to clear the maintenance informaon.
Oil Warning Light
When the oil level falls below
the low level, the oil warning
light comes on and then the
engine stops automacally.
Unless you rell with oil, the
engine will not start again.
NOTE: If the engine stalls or does not start, turn the engine
switch to “ON” and then pull the recoil starter. If the oil
warning light ickers for a few seconds, the engine oil is
insucient. Add oil and restart.