Product Manual

3534
STORAGE
In order to keep your generator trouble-free and in good
condion, proper storage preparaon is essenal. The
following steps will help to make it easier to start the engine
when you use the generator again.
Fuel
NOTICE: Fuel will deteriorate and oxidise over me. It is
important to remove fuel for longer term storage. Engine
failure due to stale fuel is not covered by warranty.
DRAINING THE FUEL
1. Remove fuel tank cap and fuel lter screen and extract
fuel into an appropriate container. Note: Fuel is extremely
volale and dangerous. Handle with cauon.
2. Turn the Engine Switch to the “ON” posion.
3. Start the engine and let it run unl the fuel runs out. The
engine will automacally stop.
4. Allow engine and generator to cool completely before
proceeding with next steps.
5. Unlock and open the le maintenance door.
6. Loosen the drain bolt on the carbureor and drain the fuel
into an appropriate container.
7. Turn the Engine Switch to the “OFF” posion.
8. Tighten the drain bolt on the carbureor.
9. Close and lock maintenance door.
Engine
• Remove the spark plug and pour about 15 ml of oil into
the cylinder.
• Turn the Engine Switch to the “OFF” posion.
• Crank the engine by pulling the manual recoil starter a few
mes to lubricate the cylinder.
• Ret the spark plug and maintenance cover.
• Clean and store the unit in a dry, dust free area out of
direct sunlight.
TROUBLESHOOTING
No. Fault Soluon
ENGINE WON’T START
1 The Engine Switch is placed on the
"O" posion.
Turn the Engine Switch to the "On"
posion.
2 Not enough fuel in the tank. Add fuel.
3 Old or stale fuel. Drain the fuel from the tank, and
rell with new gasoline.
4 Too low oil level causes the oil
alarm system to operate.
Add engine oil.
5 No spark. Remove and clean or replace worn
or damaged spark plug.
6 Ignion system fault, wiring harness
fault, valve clearance, etc.
Contact dealer
DECREASE OF OUTPUT POWER
1 Air lter element failure Clean or replace lter element.
2 Ignion system fault, wiring harness
fault, valve clearance, etc.
Contact dealers for handling.
NO OUTPUT OF CONTROL PANEL
1 AC indicator light is o, and
overload indicator light is on.
Check AC load. Stop and restart the
engine.
Check the inlet of cooling vent.
Stop and restart the engine.
2 AC Over-load buon trips out. Remove load and reset AC buon.
Check appliance before replugging
in.
3 Other engine faults. Contact dealers for handling.