Product Manual

3332
WHEEL SET INSTALLATION
Tool requirements: 12mm wrench, 10mm wrench, crosshead
screwdriver used for baery wiring, and clamp.
NOTICE: The generator must not be run without the
wheel kit ed as the wheel kit provides airow between
the ground and the airow inlet of the generator.
WARNING: If the wheel kit is not installed dust and debris
may be drawn into the air intake of the generator. This
will cause major damage to the generator and will void
the warranty.
No. Name Quanty
1 Wheel 2
2 Axle 1
3 B pin 2
4 Washer 2
5 Bolt 8
6 Frame shock absorber bracket (le) 1
7 Frame shock absorber bracket (right) 1
1. Install the wheels to the generator with two washers and
pin clamps.
2. Install the axle onto the generator with four M8x 16 bolts.
3. Install the frame shock absorber bracket (le) onto the
generator with two M8x16 bolts.
4. Install the frame shock absorber bracket (right) onto the
generator with two M8x16 bolts.
Torque: 11-16 LBS. Ft (15-22 N.M, 1.5-2.2kg.m).
TRANSPORTING
TRANSPORTATION
Before transportaon allow the generator set to cool
completely.
To prevent fuel spillage, when transporng or during
temporary storage, the generator should be secured upright
in its normal operang posion, with the all switches in the
“OFF” posion
Do not overll the tank. Do not operate the generator while it
is on a vehicle. Take the generator o the vehicle and use it in
a well-venlated place.
Avoid a place exposed to direct sunlight when pung the
generator on a vehicle.
If the generator is le in an enclosed vehicle for many hours,
high temperature inside the vehicle could cause fuel to
vaporize, resulng in a possible explosion.
Do not drive on a rough road for an extended period with the
generator on board. If you must transport the generator on a
rough road, drain the fuel from the generator beforehand.
Note: Take care not to drop or strike the generator during
transport. Do not place heavy objects on the generator. When
using e-downs to secure the generator for transportaon,
use only the two upper frame protecon bars to aach to. Do
not aach e-downs to the main body of the generator or to
any part of the folding handle.