Product Manual
OIL REPLACEMENT
!
1. Place generator on a level surface, and start engine
for few minutes to reduce the engine oil viscosity. Shut-
o the engine and remove maintenance cover as per
procedure.
① Rubber gasket
② Oil drain screw
③ Aluminum gasket
④ Oil container
2. Remove rubber gasket ① of oil drain hole from
boom plate (pull up from boom plate). Place an oil
container ④ bigger than 1L below generator, remove
oil drain screw ② and aluminum gasket ③. Tilt the
generator to drain all oil. (If possible, a more convenient
way is to use a siphon to drain the oil from engine
crankcase.)
!
NOTE: Replace aluminum gasket if damaged or if
there are leaks when it is reed.
3. Take oil container away, ret drain plug and aluminum
gasket and insert it into oil drain port, screw it by hand,
and ghten with a spanner. Re-assemble rubber gasket
on oil drain port.
4. Place generator
horizontally, and ll
oil to oil port lower
limit ①. See page
17 for oil type, lling,
etc.