Product Manual


USING THE HANDLES
!



This generator includes two (2) handles. A xed handle
is located on the rear of the generator, and a telescoping
handle is located on the front of the generator, above the
control panel.
The xed handle is used for liing the generator, if needed.
The telescoping handle is used to move the generator
wheelbarrow-style along smooth, even terrain. Always
operate on a level surface.
!



You should also unplug all cords connected to the generator
to prevent a tripping hazard and/or damage to the cords or
receptacles. Ensure that the telescoping handle is properly
stowed and locked when it is not being used to move the
generator.
EXTEND AND LOCK HANDLE
1. Press the unlocking buon in the middle of the handle.
2. While the buon is pressed, pull the bar outward from
the generator unl it is fully extended.
3. Release the buon, locking the handle in place.
RETRACT AND LOCK HANDLE
1. Press the unlocking buon in the middle of the handle.
2. While the buon is pressed, push the handle straight
into the body of the generator unl it booms out.
3. Release the buon, locking the handle in place.