Product Manual

DC APPLICATION

You may use the DC receptacle to charge external baeries.

The DC receptacle provides a regulated, polarized 12V, 6A

DC supply. The generator must be running to charge an

external baery through the DC receptacle.

CHARGING EXTERNAL BATTERIES







• To prevent the possibility of creang a spark near the

baery, connect the charging cable rst to the baery

being charged, and then to the generator. When

charging is complete, disconnect the cable rst at the

generator.

• Before connecng charging cables to a baery that is

installed in a vehicle, disconnect the vehicle’s ground

baery cable. Reconnect the vehicle's ground baery

cable aer the charging cables are removed. This

procedure will prevent the possibility of a short circuit

and sparks if you make accidental contact between a

baery terminal and the vehicle's frame or body.

• Connect the posive charging cord to the posive

baery terminal. Do not reverse the charging cables, or

serious damage to the generator and/or baery may

occur. Physical injury may also occur.







1. Start the generator (Make sure economy switch is in OFF

posion).

2. Connect charging cables to the baery terminals rst.

3. Connect the charging cable to the DC receptacle of the

generator last.

