Product Manual

STORAGE
For long term storage of your machine, follow these
prevenve procedures to guard against deterioraon.
DRAIN THE FUEL
1. Remove fuel tank cap. Drain the fuel from fuel tank
into an approved gasoline container by a commercially
available hand siphon. Then install fuel tank cap.
2. Remove carburetor drain cover, loosen the drain screw
on the carburetor oat chamber, and drain the fuel from
carburetor into an approved
gasoline container.
① Drain screw
② Carburetor drain cover
3. Tighten carburetor drain
screw, and install carburetor
drain cover.
!
WARNING: Fuel used in the machine is highly
ammable and poisonous. Check SAFETY INFORMATION
(page 9) carefully before adding the fuel. Make sure to
wipe up any spilled fuel immediately to avoid damage on
rubber or plasc parts.
4. Start the engine and let run unl it automacally stops
(As it has used all remaining fuel in carburetor).
PROTECT THE ENGINE
In order to protect engine, inside the cylinder, piston rings
and other parts, please proceed as following steps:
1. Remove the spark plug, and pour about 5ml
SAE10W\30 or 20W\40 engine oil into the spark plug hole
and then re-install the spark plug. Pull the recoil starter
several mes to coat the cylinder wall, piston rings and
other parts with engine oil.
2. Pull the recoil starter unl you feel compression and
then stop pulling (This prevents the cylinder and valves
from rusng).
Pg. 31