Product Manual

DC CONNECTION (BATTERY CHARGING)
!
WARNING: Never connect with VRLA (valve regulated
lead-acid) baery, which needs special (constant voltage)
baery charging.
!
NOTE: The generator rated DC voltage is 12V - 8 Amp.
• Make connecon to baery aer starng engine
• Clamp the red wire to the posive (+) terminal and
the black wire to the negave (-) terminal of the
baery. ① Red cable ② Black cable
STARTING THE ENGINE
1. Start the generator.
2. Press the DC
protector to reset and
connect.
① RESET
②
3. Turn the smart-
throle switch to OFF
posion.
4. Connect charging line to baery
terminal, and then plug to generator DC
socket.
!
NOTICE: Make sure the smart-throle switch is in
OFF posion while charging baery and ensure baery
lines are properly connected.
To avoid short circuit, connect charging line to baery
terminal rst, then to generator DC socket. Aer
charging, disconnect the generator terminal rst.
If DC protector turns OFF, reduce the load to the
generators rated output. If it turns OFF again, consult
your local dealer/service agent.
Pg. 22