Product Manual

4
CONNECTING DRIVE PUMP OR VIBRATOR SHAFT
• Ensure that the connecting end is securely engaged and properly latched into the drive
unit.
BEFORE STARTING
• Check the engine in accordance with operation manual for engine.
• Check fuel and engine oil.
• Check bolts and screws for tightness and make sure all bolts and screws are securely
tightened. Loose bolts and screws may cause damage to the unit.
STARTING
• Open fuel tap.
• Set the speed control lever to the starting position.
• Close the choke lever of the carburettor (leave the choke lever half-open position during
warming up the engine – petrol engine only).
• Pull the recoil starter strongly.
• After the engine has started open the choke lever fully and warm up the engine for 2-3
minutes in the low speed position.
OPERATING
• Take care not to over-speed the flexible shaft or damage could result.
• Engine speed is set to 3100RPM which is correct for vibrator shafts. Operating in excess
of this speed may cause damage to vibrator shaft.
STOPPING THE MACHINE
• Operate the machine 1-2 minutes with the throttle lever setting back to the low speed
position.
• Turn the ignition switch to “OFF” for petrol unit. Press STOP lever for diesel unit.
• Close the fuel cock.
• After the engine has cooled, it is highly recommended to wipe off the machine and
inspect oil seals for any unusual leakage from the engine.
• It is also recommended that a cover be placed over the machine once cooled, to provide
protection to the machine as well as the engine.