Operation Guide

PERIODIC MAINTENANCE
L-N Operation Manual
71
Figure 6
3. Lift out the inlet fuel screen (Figure 6, (3)).
4. Clean the inlet fuel screen or replace if
damaged.
5. Install the inlet fuel screen (Figure 6, (3)).
6. Replace the fuel cap (Figure 6, (1)) and hand
tighten. Overtightening the fuel cap will
damage it.
Perform the following maintenance every 200
hours of operation.
• Clean Air Cleaner Element
• Replace Engine Oil and Clean / Inspect
Engine Oil Filter
• Check Engine Speed Control
• Drain the Fuel Tank and Replace Outlet Fuel
Filter
Clean Air Cleaner Element
Applicable Inlet Fuel Screen Part No.
L48N, L70N and L100N 114250-55100
0001552A
(1)
(3)
(2)
Every 200 Hours of Operation
A CAUTION
FLYING OBJECT HAZARD!
• ALWAYS wear eye protection when
servicing the engine and when using
compressed air or high-pressure
water. Dust, flying debris, compressed
air, pressurized water or steam may
injure your eyes.
• Failure to comply may result in minor
or moderate injury.
0000003en
CAUTION
• When the engine is operated in dusty
conditions, clean the air cleaner
element more frequently.
• NEVER operate the engine with the air
cleaner or element(s) removed. This
may cause foreign material to enter the
engine and damage it.
0000026en
LN Series OperationManual_A4.book 71 ページ ２００６年５月１２日 金曜日 午前１０時１８分