Operation Guide

ENGINE OPERATION
40
L-N Operation Manual
Set Engine Speed Control to START
Several types of engine speed controls
are used in L-N engine applications. The
following procedures are for three typical
applications. Refer to the operating
instructions for the driven machine.
1. If your engine speed control is similar to
Figure 10 slide the engine speed control
lever (Figure 10, (1)) to the RUN position
(Figure 10, (2)).
Figure 10
2. If your engine speed control is similar to
Figure 11 slide the engine speed control
lever (Figure 11, (1)) to the RUN position or
(Figure 11, (2)).
Figure 11
3. If your engine speed control is similar to
Figure 12:
(a) Turn the engine speed control knob
(Figure 12, (1)) to the left (Figure 12, (2)).
(b) Slide the engine speed control knob to the
START position (Figure 12, (3)).
(c) Turn the engine speed control knob to the
right (Figure 12, (4)) to tighten it.
Figure 12
Start The Engine
Use the following procedure to start the engine.
1. Insert the key into the key switch.
Figure 13
STOP
SLOW
RUN
(1)
(2)
0001354A
RUN
STOP
(
2
)
(
1
)
0001355A
CAUTION
NEVER use an engine starting aid such
as ether. Engine damage will result.
0000009en
(
1
)
(
4
)
(
3
)
(
2
)
0001356A
OFF
ON
STA RT
0001549C
(2)
(1)
LN Series OperationManual_A4.book 40 ページ ２００６年５月１２日 金曜日 午前１０時１８分