User Manual

12 13
www.CrockPot.com [phone]
Crock-Pot
®
| Hook Up™ Connectable Entertaining System Owner’s Manual
For use with multiple units:
The Crock-Pot
®
Hook Up™ Connectable Entertaining System has a unique
Patent Pending electrical connector that will only allow units in the Hook Up™
system to be able to connect and draw power from each other.
NOTE: To prevent damage or shock hazards, DO NOT alter the units in
anyway to allow other appliances to be able to connect to it.
1. Select the unit you would like to be plugged into the wall outlet
(Unit A). Press down on the red Cord-Release Latch on the
right-hand side of that unit.
2. Pull out the Retractable Power Cord for Unit A and plug the cord
into a standard electrical outlet.
3. Line up the Plug Connection outlet of Unit A with the Retractable
Cord of Unit B, as shown:
NOTE: Recommended maximum number of units to plug into one outlet is
six (6) units. This may vary depending on circuit.
4. Push Unit A and Unit B together until you hear them ‘click’ into place.
NOTE: When using with multiple units side by side, make sure the plug in
Unit A is securely in place prior to connecting units together. To ensure the
units are connected properly, you can turn the temperature dial to HIGH,
LOW or WARM for each of the units and the LED indicators should
illuminate when they are rmly connected.
5. Connect other units as needed in any combination up to the recommended
total number of six (6) by adding up the “Unit ” count (see page 6, View
C for example). Refer to the icon located to the left of the power cord to
determine your unit count. (See Figure A).
WARNING: Your system was designed to connect only with other
Hook Up™ units. Do not attempt to plug in any other appliances
other than those that are sold within this system.
6. To add additional units, repeat steps 3-5 on previous page.
7. Add your ingredients to the Stoneware of each unit and cover with the
Glass Lid(s).
8. Select the temperature setting (HIGH, LOW or WARM) for each unit
based on your recipe. The Indicator Light on each unit will illuminate,
indicating that your units are on.
NOTE: WARM is only for keeping already-cooked food warm. Do not cook on the
WARM setting.
9. When nished using, turn off and unplug the rst unit that is plugged into
the electrical outlet and allow units to cool down prior to cleaning.
WARNING: Do not attempt to lift multiple units at one time when
they are connected together.
10. Once the units have cooled down, separate and pull the system apart using
the integrated handles on the bottom left and right-hand sides of each unit.
11. Once the unit has cooled, store the cord by slowly feeding the cord back
into the base until it clicks into place.
Storing the Cord
To store the cord, start close to the cord pocket. Using your thumb and
forenger, follow the pattern of the cord to guide it back in. If you seem to
get stuck, pull the cord completely out and try again.
Connecting Multiple Units Connecting Multiple Units
Unit AUnit B
Retractable
Cord
Wall
electrical
outlet
1
Counts as
Unit
Figure A
6 5 4 3 2 1
NOTE: Units do not have to be clicked tightly together to function. As long as the
male end is plugged into the female end, the units will be powered on. (See Figure B)
Figure B
Crock-Pot hook up IB_13EM3.indd 12-13 5/23/13 9:06 AM