Service manual

50
3.4.7 Reassembling the Monitor
Re-assembly is a direct reversal of disassembly, however additional care must be taken to ensure that all
cables and hoses are refitted correctly. The main points to note when reassembling are:
?? Pay particular attention to the wire dressing and ensure that all ferrite components are refitted
correctly.
?? When reassembling the chassis, remember to reconnect the valve control from the pump to the
power supply board.
?? When refitting the front panel, ensure that the copper earthing fingers of the front-panel engage
correctly inside the rear enclosure.
?? Ensure that the hoses to the front panel are not trapped or kinked while refitting the panel.
?? Keep your work area clean. It is quite easy for the plastic display panel cover to become
scratched if the front panel is pressed against a hard object such as a screw.
?? Be sure to re-calibrate and test the monitor as per section 3.4.1 and 3.4.6 before releasing
it for clinical use.
ZIF socket
Printer module
Printer board
8650AB