Service manual

5
3.2 Service Modes 29
3.2.1 The Clinician Menu (Service mode 1 2 3 4) 31
3.2.2 The Service Menu (Service mode 2 2 1 3) 32
3.3 Calibration - Checking & Re-calibrating 36
3.3.1 Checking of NIBP Calibration 36
3.3.2 NIBP Calibration 37
3.3.3 NIBP Pop Off Checking 38
3.3.4 NIBP Pop Off Pressure Calibration 39
3.3.5 Predictive Temperature Calibration Check 40
3.3.6 Predictive Temperature Calibration 40
3.4 Monitor Disassembly 42
3.4.1 Removal of the Front Panel 42
3.4.2 Removal of the Switch board, Display board and Liquid Crystal Display module 44
3.4.3 Removal of the Chassis 46
3.4.4 Removal of the Main Board and Power Supply board from the chassis 47
3.4.5 Removal of the Pump and Pressure Transducer 48
3.4.6 Removal of the Printer 49
3.4.7 Reassembling the Monitor 50
4 MANUAL RELEASE TEST PROCEDURE 51
4.1 General 51
4.1.1 Test Equipment 51
4.1.2 Test Conditions 51
4.1.3 Service mode 51
4.2 Test Procedure 52
4.2.1 Power Up Tests 52
4.2.2 External DC Supply and Battery Indication Operation 52
4.2.3 Temperature Requirements 52
4.2.4 Pulse Oximeter Requirements 53
4.2.5 NIBP Requirements 54
4.2.6 Printer Operation 55
4.2.7 Calibration Time Stamp 55
4.3 Manual Release Test Results Sheets 56
5 TROUBLE SHOOTING. 58
6 TECHNICAL INFORMATION 64
6.1 Host Port Connector (rear panel) 64
6.2 Remote Alarm Connector (rear panel) 64
6.3 Accessory Part Numbers 65
6.4 DINAMAP
™
Compact Service Spares List 69
6.5 Procedural & Error Alarm Code Table 75