Service manual

34
3.2.2.4 System
Selection of this button causes the System service menu to appear.
Error Log
When selected will produce a printout of the system errors that have occurred on unit. The Main Board and
PSU board software revision is printed out.
Language
Selection of this button allows the display language to be pre-set.
Selection of any language button removes all other language buttons from the screen, indicating that the
remaining button is the chosen language.
Selection of Clear will restore all language buttons, allowing the user to select again.
Selection of OK saves the setting to the chosen language. If no language was selected when OK was
pressed the language will be stored as undefined. The monitor will then prompt the user to select a
language on every power up until a successful selection has occurred.
Comms
Selection of this button causes the Communications menu to appear.
Selection of the Remote Operation check box toggles remote operation on and off. When on, a tick
appears next to the box, denoting that remote operation (i.e. from the central station) is possible.
Selection of the Address box allows the monitor’s address to be set within the range 1 to 255.
Selection of OK returns to the Service Menu.
System
Selection of this button causes the hardware System menu to appear.