Specifications

84
Battery charging will take place as long as the Monitor remains
connected to an external AC power source via the supplied
AC-DC power converter. A battery that is fully discharged can
be fully recharged in 1 hour 50 minutes when the Monitor is
switched off or 8 hours if the Monitor is switched on.
Cautions
• To ensure that the battery will be ready for portable
operation, keep the Monitor connected to a mains
supply whenever possible.
• Repeated failure to fully charge the battery will result in
a significant reduction in battery life.
• The expected lifetime of the battery largely depends on
the way in which the Monitor is used. If the battery is
allowed to completely discharge before being fully
recharged, the battery should survive around 200
recharge cycles. If the battery is used in such a way that
it never becomes more than one third discharged and is
fully recharged whenever possible, it can survive up to
1200 cycles. This means that by thoughtful usage, the
lifetime of the battery can be extended up to six times.
Replacement batteries may be obtained from Critikon.
Note: The replacement part number of the battery is US:
63313 or UK: 200000. Do not use other types.
Fuses
The Monitor contains two fuses. The low-voltage DC line input
power fuse is mounted on the rear of the Monitor. An
additional thermally resettable fuse, which protects the battery
circuit, is fitted inside the Monitor. This fuse does not require
user intervention.
Replacement of DC Line Input Power Fuse
At the rear of the Monitor, disconnect the input supply. Insert
a flat bladed tool such as a screwdriver or a coin into the slot
in the fuse holder and rotate counterclockwise.
Remove the fuse from the holder. Replace the blown fuse
with the appropriate type.
COMPACT MAN-REV B 1/12/99, 9:47 AM84