Specifications

82
•Soft cloths and soft-bristled brushes
•Spray bottles
Procedure
1. Prepare the enzymatic detergent according to the
manufacturer’s instructions and the 10% bleach solution,
in separate spray bottles.
2. Spray the detergent liberally on device. If the material is
dried on, allow the cuff to sit for 1 minute. For soil on
the soft part of the closure or the cuff itself, wipe the
material off with a soft cloth. For persistent
contamination on the soft part of the closure, use a soft-
bristled brush to loosen particles. Rinse with copious
amounts of distilled water. Repeat until no visible
contamination remains. For soil on the hook part of the
closure, use a soft-bristled brush to remove the material,
and rinse with copious amounts of distilled water. Repeat
until no visible contamination remains.
3. Spray the 10% bleach solution on the affected area until
the area is saturated. Allow the cuff to sit for 5 minutes.
4. Wipe away any excess solution and rinse the cuff again
with distilled water. Allow 2 hours for drying.
The user has the responsibility to validate any deviations
from the recommended method of cleaning and
disinfection.
For additional information on infection control procedures,
contact Critikon Technical Support.
Printer
If the print quality is reduced, the print head can be cleaned
with a cotton swap saturated with isopropyl alcohol. For
preventive maintenance, clean the print head once a
month.
Temperature Devices
• The probe holder and temperature calibration plug may
be removed and cleaned with a mild detergent. The
probe holder may be immersed during cleaning.
• Do not immerse the temperature calibration plug.
COMPACT MAN-REV B 1/12/99, 9:47 AM82