Specifications

14
external power is being applied and that the battery is
charging. If the battery is not inserted, the external power
indicator LED will flash. When the Monitor is running on
battery power, a battery icon appears in LCD area 3 (toggling
with the time indicator) indicating the charge status.
During battery-only operation, the yellow battery power
indicator LED (8) will light. When the battery becomes
discharged and only 10% of the full charge remains, the
indicator will begin to flash and the Monitor will sound
periodic warning beeps. At this point, the Monitor should be
connected to an AC outlet to recharge the battery. If the
Monitor continues to be used without charging the battery,
the message WARNING: THE BATTERY IS TOO LOW FOR
MONITOR TO FUNCTION. TURN MONITOR OFF appears,
and the Monitor will enter the fail-safe mode. The fail-safe
mode shuts down all functions until the Monitor is turned off
and the battery is recharged or replaced.
Battery charging will take place as long as the Monitor remains
connected to an external AC power source via the supplied
AC-DC power converter. A battery that is fully discharged can
be fully recharged in 1 hour 50 minutes when the Monitor is
switched off or 8 hours if the Monitor is switched on.
Notes
• To prolong the life of the battery, keep the Monitor
connected to an AC outlet whenever possible. NEVER
allow the battery to become completely discharged. A
fully charged battery will power the Monitor for
approximately 3 to 4 hours (Model TS and T with printer:
3 hours. Model BP and T with printer: 4 hours.) and
should survive between 200 and 500 charge/discharge
cycles. When it is necessary to replace the battery, refer to
the Compatibility Table and Reorder Codes listed in
Appendix D. To ensure full charge cycles, replace only
with a recommended battery. If the Monitor is to be
stored for some time, first charge the battery and then
remove it and store it separately from the Monitor.
• For continued safety, use only a power cord of listed type
SJT, three-conductor, min. No. 18 AWG, terminated in a
hospital grade attachment plug, provided with the
COMPACT MAN-REV B 1/12/99, 9:46 AM14