Service manual

2-4 CARESCAPE V100 Vital Signs Monitor 2048723-002D
Equipment overview: Front panel indicators
9. Cycle button: used to select NIBP mode of manual, auto cycle, or Stat mode.
10. Temperature probe cover storage: stores Alaris probe covers.
11. History button: activates the history mode to view stored patient data. The
most recent entries are displayed first. Press and hold the button for 2
seconds to clear all entries stored.
12. Print button: prints currently displayed values or all stored entries when in
history mode.
13. On/Off button: controls on/off state of monitor; push for power on and push
again for power off.
14. Alaris temperature probe connector: attach temperature probe cable here.
(The Exergen scanner connects to the host communication port at the back
of the system. Refer to “Rear panel” on page 2-6).
Front panel indicators
15. Alarm silence indicator:
 Solid red: Indicates that an alarm silence is active and the audible alarm
tones are silenced for 2 minutes.
 Blinking red (Legacy alarm mode only): Indicates that an alarm silence is
not active and at least one alarm condition is present.
16. Systolic window: indicates measured systolic NIBP in mmHg.
17. Diastolic window: indicates measured diastolic NIBP in mmHg.
18. INFLATE PRESSURE indicator: flashes to indicate you are making a change
to the inflation pressure. Adjustable for adult/ped and neonate patients.
19. ALARM VOLUME indicator: flashes to indicate you are making a change to
the alarm volume.
20. PULSE VOLUME indicator: flashes to indicate you are making a change to
the pulse volume.
HISTORY
AUTO CYCLE
MAP/Cuff
BATTERY
Pulse Rat e
Temperature
Sp O
C
F
Diastolic
Sy st o l i c
ALARM VOLUME
HIGH
HIGH
HIGH
HIGH
LOW
LOW
LOW
LOW
CH ARGI NG
PULSE VOLUME
I NFLA TE PRESSURE
16
17
18
21
22
23
15
24
25
26
28
28
29
20
19
ADULT
NEONATE
30
31
OK
27
29
30
31
32
33