Service manual

2048723-002D CARESCAPE V100 Vital Signs Monitor 2-3

Equipment overview: Front controls and connectors

Front controls and connectors

1. Silence button: mutes audible alarms. Any other active alarm that can be

acknowledged is also cleared and the alarm condition is reset whenever this

key is pressed. When pressed, the alarm silence indicator (bell) lights solid

red to indicate that audible alarms have been silenced for 2 minutes. Alarm

silence can be cancelled by pressing the Silence button again.

2. Alarms button: used to view or adjust parameter alarm limit settings.

3. +/- buttons (Plus/Minus): used when you are in the following modes: limit,

menu, cycle, and history.

 When you are in limit or menu setting, pressing the +/- button increases

and decreases an adjustable setting.

 When you are in cycle or history mode, pressing the +/- buttons

displays the next or previous cycle selection or entry in the history list,

respectively.

 When you reach the beginning or ending of a list, a negative key-click

sounds.

4. Menu button: accesses menu settings that can be adjusted: INFLATE

PRESSURE (ADULT and NEONATE), ALARM VOLUME, and PULSE VOLUME.

(Refer to “Operating modes” on page 3-5 for a description of clinical mode.)

NOTE

ADULT indicator encompasses both adult and pediatric patients.

5. SpO

sensor connector: attach SpO

cables here.

6. NIBP connector: attach NIBP cuff hoses here.

7. Inflate/Stop button: starts a manual NIBP determination or stop any NIBP

determination.

8. Temperature probe holster: stores Alaris temperature probe.