Service manual

receptable

to be used.

UPON INITIALLY RECEIVING THE MONITOR, CHARGE THE BATTERY

FOR SIXTEEN HOURS by connecting the detachable lo-foot power

cord to the monitor rear panel. Plug the other end into an appropriate

voltage receptacle and place the rear panel POWER switch into the ON

(“I”) position. (See Section 6, Maintenance for battery charging chart).

Connect the pneumatic hose to the monitor at the front panel. There is

no preferred order of connection; either hose connector may be

attached to either port. Thread the hose connectors onto monitor ports

until finger-tight. DO NOT OVERTIGHTEN. The pneumatic seal is not

made by tightening the connector.

DINAMAPTM

PORTABLE ADULT/PEDIATRIC and NEONATAL VITAL SIGNS MONITOR OPERATION MANUAL

INSTALLATION AND

INITIAL SETUP

Electrical and Hose Connections

If there is no apparent external damage to the monitor, follow these steps

With monitor power off:

Check the voltage rating stamped on the serial number plate attached

to the bottom of the monitor and make sure it matches the line voltage

of the