Service manual

rate alarm limits (see Item 18,
SELECT).
13
0 shows pulse
0 shows the alarm codes during certain alarm
conditions. Refer to Section 5,
Troubleshooting.
0 returns the values of the last determination to
all displays. There is a lo-second time limit for
each of these operations at which time the
monitor automatically returns to the previous
displays.
This white momentary pushbutton switch with
adjacent LED indicators controls and indicates the
mode of operation for the monitor, Pressing this
switch changes the operating mode as indicated
by the associated green LED.
Manual mode is entered when power is first
applied to the monitor. In manual mode, a single
determination is made each time and only when
the START switch is pressed.
In auto mode, one determination is initiated
immediately. Subsequent determinations occur at
the end of the cycle time shown in the CYCLE
MINUTES display (Item 9). Determinations may be
initiated at any time by pressing the START switch
(during wait time). The cycle timer starts when auto
mode is first entered and restarts at the beginning
of each automatic or manually started
determination.
This 3-digit yellow LED display shows pulse rate. In
addition, this LED display:
Cl allows the HIGH LIMIT and LOW LIMIT
switches to be used to display (set) the high
and low diastolic alarm limits in the DIASTOLIC
display.
Pressing the switch a fifth time
0 blanks all displays except DIASTOLIC, and
AUTO/
MANUAL
PULSE
bpm
Pressing the switch a fourth time ia
19
20
SELECT
continued
CRITIKON, INC.
SECTION 3. PHYSICAL DESCRIPTION
TABLE 3-1.
Model8100 FRONT PANEL CONTROLSAND
INDICATORS Continued
ITEM NAME
FUNCTION