Service manual

1-6 DINAMAP

ProCare Monitor Revision D

2009381-001

Introduction: Equipment Symbols

 The ProCare Monitor is designed to conform to Electromagnetic

Compatibility (EMC) standard IEC 60601-1-2 and will operate accurately in

conjunction with other medical equipment which also meets this

requirement. To avoid interference problems affecting the Monitor, do not

use the Monitor in the presence of equipment which does not conform to

these specifications.

 Place the ProCare Monitor on a rigid, secure surface. Monitor must only be

used with mounting hardware, poles, and stands recommended by GE

Medical Systems Information Technologies.

 The weight of the accessory basket contents should not exceed 5 lb (2.7kg).

 Arrange the external AC/DC power converter, air hoses, and all cables

carefully so they do not constitute a hazard.

 Verify calibration of BP parameter (temp and pulse oximeter do not require

calibration). Ensure that the display is functioning properly before operating

the ProCare Monitor.

 Do not immerse the Monitor in water. If the Monitor is splashed with water or

becomes wet, wipe it immediately with a dry cloth.

 Do not gas sterilize or autoclave.

 Use of portable phones or other radio frequency (RF) emitting equipment

near the system may cause unexpected or adverse operation.

 The equipment or system should not be used adjacent to, or stacked with,

other equipment. If adjacent or stacked use is necessary, the equipment or

system should be tested to verify normal operation in the configuration in

which it is being used.

 The ProCare Monitor, when used with GE Medical Systems Information

Technologies-approved applied parts and accessories, is protected against

defibrillator damage.

NOTE: The electromagnetic compatibility profile of the ProCare Monitor may

change if accessories other than those specified for use with the

ProCare Monitor are used.

Equipment Symbols

The following symbols are associated with the ProCare Monitor. Some of the

symbols may not appear on all equipment.

NOTE: The model of the Monitor determines which symbols appear on it.

Attention, consult accompanying documents

Silence

Alarms

+ / -