Use And Care Manual

17
ICEMAKER
Turning on the icemaker
CFRR255WD** models have a dispenser
connected icemaker located on the left side of the refrigerator
compartment.
Whenever the refrigerator is plugged in after being unplugged,
icemaking is automatically set to On. To turn icemaking Off or
On, see the instructions in Shutting icemaking off.
NOTE: As long as icemaking is turned On in the control panel,
if an icemaker stops production because the ice bin becomes
full, production will resume operation once the ice bin is
cleared of ice.
In case the icemaker doesn’t work
• Did you wait for 12 hours after installation of the water supply
line before making ice?
• Is the water line connected and the shut-off valve opened?
• Is the freezer temperature too warm? Try setting the freezer
temperature lower.
In case of power failure
In the event of a lengthy power failure, remove ice cubes in
the storage bin as the ice may melt and flow down to the ice
dispenser and leak out.
Place bin back in the icemaker assembly.
Shutting icemaking off
Important!
If you do not intend to use any ice cubes for longer than
one week (e.g. because you are going on holiday), shut off
icemaking for that period to prevent ice cubes from freezing
together.
1. To turn OFF :
Press and hold Water and Ice Type buttons at same time
for 3 seconds until Ice Off illuminates in the control panel
display.
To turn ON :
Press and hold Water and Ice Type buttons at same time
for 3 seconds until Ice Off ceases to illuminate in the
control panel display.
2. Empty and clean the ice cube bin.
To remove ice bin from dispenser icemaker, grasp front of
ice bin and pull forward.
To remove freezer ice bin, pull freezer drawer all the way
forward and lift ice bin up and out of pullout drawer.
NOTE: There is a fingerhold indentation on the bottom front of
the dispenser ice bin for ease of bin removal.
3. Return the ice cube bin into position.
NOTE: The ice bin should be emptied any time the icemaker
is turned off.
USING YOUR REFRIGERATOR