Use And Care Manual

REFRIGERATOR LEVELING &

DOOR ADJUSTMENT

The refrigerator must be level in order to maintain optimal

performance and desirable front appearance.

(If the floor beneath the refrigerator is uneven, the freezer and

refrigerator doors look unbalanced.)

Leveling Refrigerator

1. Pull open the freezer compartment and remove the upper

drawer and lower drawer basket to gain access.

2. Using the wrench provided, turn the leveling leg clockwise

to lower and counterclockwise to raise the front corners of

the refrigerator.

3. Install the lower drawer basket and upper drawer, then

open and close the freezer compartment several times to

make sure operation is smooth and without hindrance.

Adjusting a refrigerator door

If the height of the refrigerator doors is uneven, turn the screw nut

on the middle hinge to adjust the refrigerator door.

1. To raise a refrigerator door turn the screw

counterclockwise.

2. To lower a refrigerator door turn the screw clockwise.

Adjusting the freezer drawer

If the freezer drawer is lower on one side than the other,

perform the steps listed below to raise that side. To access

the adjustment components, first pull the drawer out to full

extension. then remove the pullout drawer and the freezer

basket.

1. Loosen the four screws on the rail bracket on the side

where adjustment is needed.

2. Unscrew and remove Stopper and at washers from the

lower position (left picture). Insert washers and screw

Stopper into the upper position (right picture). The stopper

will serve as a fixed edge against which to turn the Position

Knob to adjust the height of the rail bracket.

3. S lightly pull the Position Knob forward and firmly rotate it to

a different position, then release the knob back into place.

The knob surfaces push against the edge of the stopper

ring to vary the height of the rail bracket. The maximum

adjustment variance is approximately 1/8 inch.

4. Retighten the four rail bracket screws.

5. Reinsert the freezer basket and pullout drawer.

When inserting the basket, make sure that the tabs at the

front of the basket fit into the slots on the freezer drawer

rails.

Raise Lower

REFRIGERATOR INSTALLATION