Use And Care Manual

13
HOW TO INSTALL THE FREEZER DRAWER
1. Using 2 people (recommended), align end of the exterior
drawer rails to the lower rail guides located on the
sidewalls of the freezer compartment. Make sure the gear
teeth are engaged to the gear rail the same amount on
both sides.
2. Fully push in and close freezer drawer to engage rails with
rail support locking tab, applying a bit of pressure after the
door is closed to seat the tabs to the rail.
CAUTION:
Make sure the tabs are completely engaged
to the rail or the refrigerator drawer could be pulled out of
the refrigerator by the user. Fully open the freezer door to
check and see if the locking tabs are fully engaged. If they
are not engaged, gently push each freezer rail with a f lat
head screwdriver towards the freezer compartment until
the locking tabs snap to the locked position.
3. Replace the lower freezer drawer basket.
4. Insert the upper freezer drawer above the lower basket,
and replace ice bin into upper drawer.
5. Open and close the freezer drawer several times to make
sure operation is smooth and seal is consistent all the way
around the freezer compartment.
REFRIGERATOR INSTALLATION
This shows that
the tab is not fully
locked
If the tab is not fully engaged,
use a f lat screwdriver to push on
the rail as shown to allow the tab
to snap into position
This shows that the
tab is fully in the
locked position