Use And Care Manual

10
REMOVING AND REPLACING
REFRIGERATOR DOORS
WARNING
Risk of electric shock!
Before removing top hinge cover
• Shut off the water supply to the appliance.
• U nplug the appliance or switch off power from the
breaker or fuse panel.
To remove the left refrigerator door:
1. Remove top hinge cover using a phillips screwdriver by
removing 5 screws.
2. Remove the hinge grounding wire screw and pull the
two grounding wire connections away from the hinge.
Disconnect the three wire harnesses and the water tube.
Push in the small first ring on the connection collar to
remove the tube.
3. Using a large phillips screwdriver, turn top hinge fastener
counterclockwise to remove the top hinge plate.
CA UTION: After the hinge is removed, the door can fall
down forward. Hold the door to prevent it from falling.
4. Lift the door from the middle hinge pin and remove the
door. Place the door, inside facing up, on a non-scratch
surface.
To remove the right refrigerator door:
1. Remove top hinge cover using a phillips screwdriver by
removing 5 screws.
2. Using a large phillips screwdriver, turn top hinge fastener
counterclockwise to remove the top hinge plate.
CA UTION: After the hinge is removed, the door can fall
down forward. Hold the door to prevent it from falling.
3. Lift the door from the middle hinge pin and remove the
door. Place the door, inside facing up, on a non-scratch
surface.
the appliance.
down.
appliance.
2. Mount the base plate.
tighten.
properly aligned:
WARNING
Risk of electric shock!
Before removing the top panel:
1. Shut off the water supply to the
appliance.
REFRIGERATOR INSTALLATION
Push In