Use And Care Manual

Troubleshooting (con’t)
19
PROBLEM
• The temperature
is too hot.
• The temperature
is too cold.
• Ice is not
dispensing.
dispensing.
• Water is not
dispensing.
POSSIBLE CAUSE & SOLUTION
• You may have left the doors open too long or opened them
too frequently.
• Make sure that no obstacle is keeping the doors from closing
correctly.
• Adjust the refrigerator or freezer compartment temperature.
See Setting the refrigerator temperature on page 11 or Setting
See Setting the refrigerator temperature on page 11 or Setting
the freezer temperature on page 10.
• Your refrigerator may not have enough clearance from walls or
the ceiling. See Providing correct ventilation on page 7.
• Adjust the refrigerator or freezer compartment temperature.
See Setting the refrigerator temperature on page 11 or Setting
the freezer temperature on page 12.
•
• After you install the water supply line, you should wait 12 hours
before you try dispensing ice. If the water is not sufficiently cooled,
your refrigerator will take longer to make ice.
• Make sure that the water line is connected and the water valve
open. See Connecting the water supply on page 25.
• Make sure that the ice dispenser is not in off mode.
• Make sure that no ice is blocking the ice maker bucket or ice chute.
• If the water pressure is less than 30 psi, try installing a booster
• If the water pressure is less than 30 psi, try installing a booster
pump to compensate for the low pressure.
• Make sure that the freezer compartment temperature is not set
too warm. Try setting the freezer temperature lower. See Setting
the freezer temperature on page 12.
• If you just dispensed a large amount of ice, wait at least 90 minutes
before dispensing more ice.
• Make sure that the water line is connected and the water valve
• Make sure that the water line is connected and the water valve
open. See Connecting the water supply on page 25.
• Make sure that the water line is not kinked or bent.
• Make sure that the refrigerator compartment temperature is not
set too low. If the temperature is too low, the water in the dispenser
tank may freeze. See Setting the refrigerator temperature on
page 11.
• Make sure that the water filter is correctly installed. See Replacing
• Make sure that the water filter is correctly installed. See Replacing
the water filter on page 12.