Installation Instructions
Adjusting the Temperature
The internal temperature of the unit is controlled by a thermostat. The recommended
position is between 1 to 3 for colder working environments (i.e. during winter) and
between 4 to 5 for hotter environments. Please adjust according to the environment.
Noises Inside the Unit!
You may notice that your unit makes some unusual noises. Most of these are perfectly
normal, but you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling system.
It has become more pronounced since the introduction of CFC free gases. This is not
a fault and will not affect the performance of your unit. This is the compressor motor
working, as it pumps the refrigerant around the system.
Operation
Operation Switching On Your Unit
1. Connect the mains cable to the mains
socket. The internal temperature of your unit
is controlled by a thermostat. There are six
settings, of which position 5 is the coldest and
position 0 turns the unit off.
2. Adjust the thermostat control dial to the
desired position, bear in mind that the higher
the number, the lower the temperature. Position
3 recommended setting when operating at
normal room.
3. The unit may not operate at the correct
temperature if it is in a particularly hot or a
particularly cold room, or if you open the door
often.
4. To ensure that the unit is cool enough to
sufciently chill your food, wait 24 hours before
lling it with food.