Installation Instructions

Defrosting
Frost may accumulate on the inner rear surface of the appliance which will automatically
defrost during the off cycle of the compressor.
Water is channelled via the drain hole to the collection tray above the compressor
where it will evaporate.
Please ensure the drain hole is checked and cleaned on a regular basis so water can
exit the storage compartment.
Cleaning the Interior and the Exterior of the Unit
• Remove the shelf before cleaning.
• Wipe the inside of the unit with a weak solution of bicarbonate soda and then rinse
with warm water using a ‘wrung-out’ sponge or cloth. Wipe completely dry before
replacing the shelf.
• Use a damp cloth to clean the exterior, and then wipe with a standard furniture polish.
Make sure that the door is closed to avoid the polish getting on the magnetic door seal
or inside the unit.
• The grille of the condenser at the back of the unit and the adjacent components can be
vacuumed using a soft brush attachment.
Cleaning Tips
Condensation may appear on the outside of the unit. This may be due to a change
in room temperature. Wipe off any moisture residue. If the problem continues, please
contact a qualied technician for assistance.
Cleaning