Manual

54
VW4600-0002VW4600-0002
2a
2b
8mm x 65mm
A
Washer
U
Fasten wall plate to wall using screw (A) and washer (U).
Fije la placa de pared a pared con el tornillo (A) y la arandela (U).
Fixer la plaque murale au mur avec la vis (A) et la rondelle (U).
INSTALL WALL PLATE-BLOCK & CONCRETE2a
Fasten wall plate to wall using screw (A) and washer (U).
Fije la placa de pared a pared con el tornillo (A) y la arandela (U).
Fixer la plaque murale au mur avec la vis (A) et la rondelle (U).
INSTALL WALL PLATE-WOOD STUD2b
Align mount bracket (E) to holes on back of TV. Fasten using supplied hardware with
a screwdriver. Hand tools only.
Alinee el soporte de montaje (E) a los agujeros en la parte posterior de la televisión. Sujete con
partes que vienen con un destornillador. Herramientas de mano solamente.
Aligner le support de montage (E) dans les trous à l’arrière du téléviseur. Fixer à l’aide de maté-
riel fourni avec un tournevis. Outils à main seulement.
.
3-1
ATTACH MOUNT BRACKETS
3-4
If screws bottom out use washers (not included) to eliminate slack.
Si los tornillos tocó fondo a continuación, utilizar arandelas (no incluidos) para elimi-
nar la holgura.
Si les vis touché le fond, puis utiliser des rondelles (non inclus) an d’éliminer mou.
ATTACH MOUNT BRACKETS3-4
!
3-2
Multi-washer
(V)
Screws
(F-M)
3-1
Screws
(N-P)
DO NOT USE
Multi-washer
If screws (F-M) are needed use multi-washer (V).
Si los tornillos (F-M) se necesitan, a continuación, utilizar múltiples arandela (V).
Si les vis (F-M) sont nécessaires, puis utilisez multi-rondelle (V).
ATTACH MOUNT BRACKETS3-2
3-3
Spacer
R or S
Use spacers (R / S) between TV and mount if needed.
Utilice espaciadores (R / S) entre la televisión y montar si es necesario.
Utiliser des entretoises (R / S) entre le téléviseur et le support métallique si nécessaire.
ATTACH MOUNT BRACKETS3-3
1b-1
1b-3
Insert (B) into both holes. Use a hammer to tap in if necessary.
Insertar (B) en ambos oricios. Utilice un martillo para golpear en caso de necesidad.
Insérer (B) dans les deux trous. Utilisez un marteau pour enfoncer dans le cas échéant.
1b-3
MASONRY BLOCK & CONCRETE INSTALLATION
B
Level wall plate, then mark 6 hole locations.
Nivele la placa de pared, a continuación, marque la ubicación de 6 agujeros.
Niveau de la plaque murale, puis marquer l’emplacement des 6 trous.
MASONRY BLOCK & CONCRETE INSTALLATION
1b-1
1b-2
drill depth
65mm / 2.5”
drill diameter
11mm
7/16”
Use 11 mm-7/16“ drill bit to drill 65mm - 2.5” holes on marks.
Utilice un 11 mm-7/16“ para perforar la madera poco 65mm - 2.5” agujeros.
Utilisez un
11 mm-7/16“ bits de forage pour percer 65mm - 2.5” po.
1b-2
MASONRY BLOCK & CONCRETE INSTALLATION